A
-
Abyanaki, Mohammadreza
A robust engineering approach for wind turbine blade profile aeroelastic computation [Volume 2, Issue 2, 2014, Pages 121-128]
-
Afshari, Ebrahim
An analytic model of membrane humidifier for proton exchange membrane fuel cell [Volume 2, Issue 1, 2014, Pages 83-94]
-
Ahmadi, Pouria
Aerodynamic optimal design of wind turbine blades using genetic algorithm [Volume 2, Issue 2, 2014, Pages 185-193]
-
Akhavan Bahabadi, Mohammad Ali
Investigation of a single-reheat condensing steam power plant based on energy and exergy analysis [Volume 2, Issue 2, 2014, Pages 155-170]
-
Ashjaee, Mehdi
Conceptual design of a super-critical CO2 brayton cycle based on stack waste heat recovery for shazand power plant in Iran [Volume 2, Issue 1, 2014, Pages 95-101]
B
-
Baharlou Houreh, Nasser
An analytic model of membrane humidifier for proton exchange membrane fuel cell [Volume 2, Issue 1, 2014, Pages 83-94]
-
Bahrampoury, Rasool
Multi-objective optimization of heat recovery steam generators [Volume 2, Issue 2, 2014, Pages 129-140]
-
Baigmohammadi, Mohammadreza
A numerical study on the effects of hydrogen addition levels, wall thermal conductivity and inlet velocity on methane/air pre-mixed flame in a micro reactor [Volume 2, Issue 2, 2014, Pages 103-119]
-
Behbahaninia, Ali
Multi-objective optimization of heat recovery steam generators [Volume 2, Issue 2, 2014, Pages 129-140]
H
-
Hadi Jafari, Pantea
Thermoeconomic comparison between the performance of small-scale internal combustion engines and gas turbines integrated with a biomass gasifier [Volume 2, Issue 1, 2014, Pages 57-82]
-
Hanafizadeh, Pedram
Simulation of gas-liquid two phase flow in upriser pipe of gas-lift systems [Volume 2, Issue 1, 2014, Pages 25-42]
-
Hanafizadeh, Pedram
Investigation of a single-reheat condensing steam power plant based on energy and exergy analysis [Volume 2, Issue 2, 2014, Pages 155-170]
-
Härkegård, Gunnar
A review on fatigue design of heavy section EN-GJS-400-18-LT ductile iron wind turbine castings [Volume 2, Issue 1, 2014, Pages 5-24]
I
-
Iranmanesh, Masoud
Energy auditing in cement industry: A case study [Volume 2, Issue 2, 2014, Pages 171-184]
K
-
Kashir, Babak
A numerical study on the effects of hydrogen addition levels, wall thermal conductivity and inlet velocity on methane/air pre-mixed flame in a micro reactor [Volume 2, Issue 2, 2014, Pages 103-119]
-
Keynia, Farshid
Energy auditing in cement industry: A case study [Volume 2, Issue 2, 2014, Pages 171-184]
-
Kowsary, Farshad
Thermoeconomic comparison between the performance of small-scale internal combustion engines and gas turbines integrated with a biomass gasifier [Volume 2, Issue 1, 2014, Pages 57-82]
M
-
Mirhosseini, Mojtaba
Aerodynamic design and economical evaluation of site specific horizontal axis wind turbine (HAWT) [Volume 2, Issue 1, 2014, Pages 43-56]
-
Mirzakhani Siahkalroudi, Mojtaba
Investigation of a single-reheat condensing steam power plant based on energy and exergy analysis [Volume 2, Issue 2, 2014, Pages 155-170]
-
Moezzi, Mahsa
Simulation of gas-liquid two phase flow in upriser pipe of gas-lift systems [Volume 2, Issue 1, 2014, Pages 25-42]
-
Moghimi Zand, Mahdi
Aerodynamic design and economical evaluation of site specific horizontal axis wind turbine (HAWT) [Volume 2, Issue 1, 2014, Pages 43-56]
N
-
Nejat, Amir
A robust engineering approach for wind turbine blade profile aeroelastic computation [Volume 2, Issue 2, 2014, Pages 121-128]
R
-
Rahbari, Iman
A robust engineering approach for wind turbine blade profile aeroelastic computation [Volume 2, Issue 2, 2014, Pages 121-128]
-
Rahmani, Kiana
Aerodynamic optimal design of wind turbine blades using genetic algorithm [Volume 2, Issue 2, 2014, Pages 185-193]
S
-
Safari, Mohammad
Improvement of thermal performance of a solar chimney based on a passive solar heating system with phase-change materials [Volume 2, Issue 2, 2014, Pages 141-154]
-
Saidi, Mohammad Hassan
Simulation of gas-liquid two phase flow in upriser pipe of gas-lift systems [Volume 2, Issue 1, 2014, Pages 25-42]
-
Sedaghat, Ahmad
Aerodynamic design and economical evaluation of site specific horizontal axis wind turbine (HAWT) [Volume 2, Issue 1, 2014, Pages 43-56]
-
Seddighi, Amirreza
Conceptual design of a super-critical CO2 brayton cycle based on stack waste heat recovery for shazand power plant in Iran [Volume 2, Issue 1, 2014, Pages 95-101]
-
Shirani, Mehdi
A review on fatigue design of heavy section EN-GJS-400-18-LT ductile iron wind turbine castings [Volume 2, Issue 1, 2014, Pages 5-24]
-
Sokhansefat, Tahmine
Aerodynamic optimal design of wind turbine blades using genetic algorithm [Volume 2, Issue 2, 2014, Pages 185-193]
T
-
Tabejamaat, Sadegh
A numerical study on the effects of hydrogen addition levels, wall thermal conductivity and inlet velocity on methane/air pre-mixed flame in a micro reactor [Volume 2, Issue 2, 2014, Pages 103-119]
-
Tahani, Mojtaba
Aerodynamic optimal design of wind turbine blades using genetic algorithm [Volume 2, Issue 2, 2014, Pages 185-193]
-
Tahmasebipour, Amir
Conceptual design of a super-critical CO2 brayton cycle based on stack waste heat recovery for shazand power plant in Iran [Volume 2, Issue 1, 2014, Pages 95-101]
-
Torabi, Farschad
Improvement of thermal performance of a solar chimney based on a passive solar heating system with phase-change materials [Volume 2, Issue 2, 2014, Pages 141-154]
Your query does not match with any item